Bush BTVD91186B User Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
For any help concerning set up and use of your TV please call the Customer Helpline: 0845 604 0105
11
Using the Remote Control
• Point the remote control at the REMOTE
SENSOR located on the unit.
• Whenusingthisunitinaverybrightlylitarea,
the infrared REMOTE CONTROL SENSOR may
not work properly.
• Therecommendedeffectivedistanceforusing
the remote control is about 16 feet (5 metres).
To Change the Remote Control Batteries
Open the battery door. (g.1a)
Insert two “AAA” batteries. (g.1b)
Battery Replacement
Whenthebatteriesbecomeweak,theoperating
distance of the remote control will be greatly reduced
and you will need to replace the batteries.
Note:
If the Remote Control is not to be used for a
long time, remove the batteries to avoid damage
caused by battery leakage corrosion.
Do not mix old and new batteries. Do not mix
ALKALINE, standard (CARBON-ZINC) or
rechargeable (NICKEL-CADMIUM) batteries.
Corrosion, oxidation, battery-leakage and any
other gradually acidic defect of this nature will
invalidate the guarantee.
When discarding batteries, environmental
problems must be considered and local rules or
laws governing the disposal of these batteries
must be strictly followed.
CAUTION:
Danger of explosion if batteries are incorrectly
replaced. Replace only with the same or
equivalent type.
WARNING:
Do not dispose of batteries in a re or
they may leak and/or explode.
The battery shall not be exposed to
excessive heat such as sunshine, re or
the like.
Remote control
Getting Started
g.1a
g.2b
BTVD9xxx6_IB_BUSH 2011_Rev3.indd 11 6/1/2011 16:27:34
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments